Floodstop valve manual

Manual FloodStop by Shut o˜ the manual cold water valve that supplies water to the water heater. Note that the top of the water heater will usually be marked “Cold” or “Inlet” at the point where the cold water line is connected. 4. Position the LeakSmart Valve so that the arrow on theFile Size: 2MB. Manual Operation of FloodStop Valve- If an AC Adaptor extension wire was used, unplug both ends and reconnect. - Make sure fresh batteries are in the Control Panel. No water comes out of hot side of faucet - Push Open button to make sure FloodStop Valve is open. - Make sure the manual cold water valve is open. Only one FloodStop Valve operates - Unplug 6-pin connector from Control Panel and reconnect. - Locate plug connection between Control Panel and the FloodStop Valve that does not operate. Unplug the connection and reconnect, making sure arrows on side of plugs line up. - Push the Close button and wait a few www.doorway.ru Size: 1MB.

Manual Operation of FloodStop Valve What to Check Locate plug connection between Control Panel and FloodStop Valve. Unplug the connection and reconnect, making sure arrows on the side of plugs line up. If an AC Adaptor extension wire was used, unplug both ends and reconnect. Floodstop is a of point-of-use leak detection device that automatically shuts off the water supply to the appliance the moment a leak is detected. Once water is detected, the motorized ball valves close and sound an alarm. FloodStop devices limit potentially devastating flood damage, allowing the plumber, builder, and homeowner to have peace-of. Wire harness for any FloodStop unit with one valve. XS Extra FloodStop Sensor Pad. XS Extra FloodStop Sensor Pad. Only for use with FloodStop leak detection equipment. Floodstop extra sensor pad to protect more than one area at a time or to "daisy chain" to extend your reach. 3' of wire.

Only one FloodStop Valve operates - Unplug 6-pin connector from Control Panel and reconnect. - Locate plug connection between Control Panel and the FloodStop Valve that does not operate. Unplug the connection and reconnect, making sure arrows on side of plugs line up. - Push the Close button and wait a few seconds. Position the FloodStop Valve so that the arrow on the side of the valve is pointing to the water heater. Install the FloodStop Valve between the rigid water line coming from the manual cold water valve and the water heater. Cold CLOSE Operating Manual FSINPT © OnSite PRO Inc. NOTE: The FloodStop Valve should be installed within 2. 2) Remove the existing supply line from the manual shutoff valve. 3) Connect the FloodStop valve downstream of the manual shutoff valve (as close to the manual shutoff valve as possible). 4) Connect the water supply line to the outlet side of the FloodStop valve, which leads to the appliance. Use pipe sealant or Teflon tape for NPT/water.